很多人在購買完鋁卷之后，一定要記得放置好 ,因為放置的不到位，很容易讓鋁卷出現氧化的情況，這樣就失去了我們購買鋁卷的意義了。因此大家有必要了解一下鋁卷應該放置在什么地方。
Many people must remember to place the aluminum coil well after purchasing it, because if it is not placed in place, it is easy to cause the aluminum coil to oxidize, thus losing the significance of our purchase of aluminum coil. Therefore, it is necessary to know where the aluminum roll should be placed.
1.將鋁卷用塑料薄膜包妻好，如果條件允許的話，好是放置在有干燥劑的地方，這樣能夠將空氣里面的水分吸收，從而避免了出現氧化的問題；
1. Wrap the aluminum roll with plastic film. If conditions permit, it is better to place it in the place with desiccant, so as to absorb the moisture in the air and avoid the oxidation problem;
2.如果鋁卷是放在木箱里面的，那么我們要保證木箱的濕度要小于18% ,而且鋁卷的溫度不能高于45°C ,大家不要記錯了；
2. If the aluminum coil is placed in the wooden box, then we should ensure that the humidity of the wooden box is less than 18%, and the temperature of the aluminum coil should not be higher than 45 ° C. don't make mistakes;

3.如果在放置期間突然由低溫區域轉到高溫區域，那么我們不要立即將包裝打開，因為這樣很容易出現氧化的情況，我們應該等到鋁卷適用之后在進行拆封，這樣就不會出現氧化的情況；
3. If it suddenly changes from the low temperature area to the high temperature area during the storage, we should not open the package immediately, because it is easy to oxidize. We should wait until the aluminum coil is applicable before unpacking, so that there will be no oxidation;
4.如果倉庫里面漏雨、漏雪，那么不應該放置鋁卷，這樣很容易讓其出現氧化的情況，這一點一定要切記。
4. If there is leakage of rain and snow in the warehouse, aluminum coil should not be placed, which is easy to cause oxidation. This must be remembered.
鋁卷既可以整卷包裝，也可以分成小卷；鋁卷襯紙芯或鋁芯，以防止鋁卷變形，或受擠壓發生彎折；鋁卷要用塑料布密封，封口用透明膠帶密封好，防止水汽進入造成鋁卷腐蝕變色外包裝使用厚紙殼包裝緊實，也可在塑料布與紙殼之間加一層牛皮紙，將包裝好的鋁卷放置在木托上，并用鋼帶加固。
The aluminum coil can be packaged in whole or in small coils; the aluminum coil is lined with paper core or aluminum core to prevent the aluminum coil from deformation or bending due to extrusion; the aluminum coil shall be sealed with plastic cloth, and the sealing shall be sealed with transparent tape to prevent water vapor from entering into the aluminum coil to cause corrosion and discoloration of the aluminum coil. The outer packaging shall be tightly packed with thick paper shell, and a layer of kraft paper can be added between the plastic cloth and the paper shell to make the packaged aluminum The rolls were placed on wooden brackets and reinforced with steel strips.